VADDIO EasyTalk User's Guide download pdf (Page 28)

EasyTalk USB Tools

Vaddio EasyTalk USB Solution - Document Number 342-0449 Rev B Page 28 of 48

EasyTalk Ceiling Speaker Installation:

A complete set of installation instructions are provided with the Bose DS16F ceiling speakers packaging.

Diagram: Installing Ceiling Speakers in Ceiling Tile

STEP 1: Identify desired location of the ceiling tile for the speaker to be

installed in. Use included template to cut hole in tile. Again safety comes first.

STEP 2: Place Tile Support Brace in ceiling over the top of the open hole.

STEP 3: Insert ceiling speaker in the hole extending through the Tile Brace.

STEP 4: Tighten hanging tabs with screws located on the face of speaker to adhere to Tile Support Brace.

Step 5: Connecting Speaker to EasyUSB Mixer/Amp

After the ceiling speaker is installed, the speaker must be attached to the speaker terminals of the EasyUSB

Mixer/Amp. Remove the connector cover on top of ceiling speaker. Connect speaker wire to the terminal block

using the 8-ohm and common terminals. Replace the wire cover. Put the plenum back cans on when finished.

Behind the grill of the speaker, set the rotary dial to 8 ohm.



8-ohm setting on

front of speaker

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

No comments

VADDIO EasyTalk User's Guide Page 28